Programmable Power Guard Phidget - SAF1000_0

Programmable Power Guard Phidget - SAF1000_0 When high-power motor stalls or stops suddenly, it can generate a high-voltage surge that can damage the circuitry of the motor controller and burn out the power supply. This Power Guard Phidget is designed to protect your hardware from such an event by preventing current from flowing back into the power supply, and by providing a heatsink and fan for the excess power to dissipate. This board is designed for high current systems and is capable of protecting your equipment from even the largest of power spikes. Simply connect your power supply's positive wire to the 8-30V input lug, connect your device's positive wire to the output lug, and wire both grounds to the ground lug. The SAF1000 connects to a port on a VINT Hub. See the "Compatible Products" tab for a list of hubs. Power Control and Safety Features Since this is an intelligent VINT device, the overvoltage trigger can be modified in software to accommodate for different power supplies. Similarly, the fan can be switched on or off, or it can be set to turn on when a certain temperature threshold is passed. You can also choose to switch the power off through software, like a relay. Even if communication between this board and the computer is interrupted, it will continue to power the device and protect against the last chosen overvoltage trigger. Isolated for Stability The VINT port on this board is electrically isolated from the rest of the board in order to improve stability by eliminating ground loops. We strongly recommend using this Phidget according to the table below: Recommended Use Controller Motor Rated Current Suggested Power Guard STC1000 Less than 1.5A None STC1000 1.5A to 5A SAF2000 STC1000 Greater than 5A SAF1000 DCC1000 Less than 1A None DCC1000 1A to 5A SAF2000 DCC1000 Greater than 5A SAF1000 Product Specifications Board Properties Controlled By VINT Power Supply Protector Overvoltage Setting Selectable via software 8 - 33 VDC Overtemperature Trigger 125 °C Sampling Interval Min 100 ms/sample Sampling Interval Max 60 s/sample Fan Trigger 75 °C Electrical Properties Continuous Current 50 A Current Consumption Min (VINT Port) 100 μA Supply Voltage Min 8 V DC Supply Voltage Max 30 V DC Power Consumption 250 mW Physical Properties Recommended Wire Size 6 - 14 AWG Operating Temperature Min -40 °C Operating Temperature Max 85 °C